A layup list that actually gets done
Most layup lists fail because they are written in the order the jobs occur to you rather than the order the boat needs them. Do these six in this order and nothing gets done twice.
1. Wash before you cover
Salt left under a cover spends the winter in contact with everything you own. A hose and a soft brush is enough; this is not the moment for the two-part teak brightener, which wants warm weather and a long rinse.
2. Drain everything that holds water
Raw water strainer, exhaust elbow, water heater, the shower sump nobody remembers. Anything that holds a cupful will freeze and split it.
3. Fog the engine, then change the oil
In that order. Running it to temperature to change the oil undoes the fogging, and fogging a cold engine puts the oil where you are about to drain it from.
4. Pull the line, do not coil it wet
Wet three-strand left coiled on a dock goes hard and grey. Rinse it, hang it loose somewhere with air, and look at the eye splices while they are in your hands. See dock line if a splice has gone furry.
5. Wax what you can reach
Not for the shine. A coat of paste wax on the topsides is a winter’s worth of UV protection for twenty minutes of work, and it comes off in the spring with a hose.
6. Cover it so air moves
A cover that seals is a cover that grows mould. Leave the ends open or put a vent in it.
Any of this can be done out of order. Doing step three before step two is the one that costs money.